Documentation
Table of Contents
9 Web service Áú»¢¶Ä²©
Aper?u
Le Web service Áú»¢¶Ä²© est un processus utilis¨¦ pour communiquer avec des Web services externes.
Cette section r¨¦pertorie les param¨¨tres pris en charge dans un fichier de configuration du Web service Áú»¢¶Ä²© (zabbix_web_service.conf).
Notez que :
- Les valeurs par d¨¦faut refl¨¨tent les valeurs par d¨¦faut du processus, et non les valeurs des fichiers de configuration livr¨¦s?;
- Áú»¢¶Ä²© prend en charge les fichiers de configuration uniquement en encodage UTF-8 sans ?;
- Les commentaires commen?ant par "#" ne sont pris en charge qu'en d¨¦but de ligne.
Parameter details
AllowedIP
A list of comma delimited IP addresses, optionally in CIDR notation, or DNS names of Áú»¢¶Ä²© servers and Áú»¢¶Ä²© proxies. Incoming connections will be accepted only from the hosts listed here.
If IPv6 support is enabled then 127.0.0.1, ::127.0.0.1, ::ffff:127.0.0.1 are treated equally and ::/0 will allow any IPv4 or IPv6 address. 0.0.0.0/0 can be used to allow any IPv4 address.
Example:
Mandatory: yes
DebugLevel
Specify the debug level:
0 - basic information about starting and stopping of Áú»¢¶Ä²© processes
1 - critical information;
2 - error information;
3 - warnings;
4 - for debugging (produces lots of information);
5 - extended debugging (produces even more information).
Default: 3
Range: 0-5
ListenPort
The service will listen on this port for connections from the server.
Default: 10053
Range: 1024-32767
LogFile
The name of the log file.
Example:
Mandatory: Yes, if LogType is set to file; otherwise no
LogFileSize
The maximum size of a log file in MB.
0 - disable automatic log rotation.
Note: If the log file size limit is reached and file rotation fails, for whatever reason, the existing log file is truncated and started anew.
Default: 1
Range: 0-1024
LogType
The type of the log output:
file - write log to the file specified by LogFile parameter;
system - write log to syslog;
console - write log to standard output.
Default: file
Timeout
Spend no more than Timeout seconds on processing.
Default: 3
Range: 1-30
TLSAccept
What incoming connections to accept:
unencrypted - accept connections without encryption (default)
cert - accept connections with TLS and a certificate
Default: unencrypted
TLSCAFile
The full pathname of the file containing the top-level CA(s) certificates for peer certificate verification, used for encrypted communications between Áú»¢¶Ä²© components.
TLSCertFile
The full pathname of the file containing the service certificate or certificate chain, used for encrypted communications with Áú»¢¶Ä²© components.
TLSKeyFile
The full pathname of the file containing the service private key, used for encrypted communications between Áú»¢¶Ä²© components.